WOL not working on Centos 6.4

Taking care of your Linux box.
mashkoor.qadir
Lance Naik
Posts: 32
Joined: Mon Dec 20, 2010 10:27 pm
Location: Karachi
Contact:

WOL not working on Centos 6.4

Postby mashkoor.qadir » Wed Oct 14, 2015 3:43 pm

Dear all,

I am starting my remote machine with help of a magic packet by using ether-wake utility. CentOS-6.4 64-bit has been installed on it. "ETHTOOL_OPTS="wol g" is configured in /etc/sysconfig/network-script/ifcfg-eth0.

below is out put of ethtool

#ethtool eth0
Settings for eth0:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supported pause frame use: No
Supports auto-negotiation: Yes
Advertised link modes: 1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 2
Transceiver: internal
Auto-negotiation: on
MDI-X: on
Supports Wake-on: pumbg
Wake-on: g
Current message level: 0x00000007 (7)
drv probe link
Link detected: yes


My Desktop Server is HP compaq 8200 minitower convertible pc
Network card is Intel 82597LM Giga bit network.

Problem:

When I am sending the magic packet to the remote machine on LAN, it receive the magic packet, that I can see that it's power lights are on. But on the screen it only show a blinking cursor blinking on it for many hours. But do not load the POST process/boot into the operating system. However an other machine is booting fine. Both machines have same configurations.

Please help.

Thanks in advance.

Return to “Administration”

Who is online

Users browsing this forum: Baidu [Spider] and 1 guest