If you're a NetEqualizer user and would like see the amount of bandwidth usage (instantaneous usage) in a pool, simply use the following command in the command line:
brctl getpeak my <pool#>
To see the amount of bandwidth usage (instantaneous usage) on a VLAN, you will first need to set up a VLAN shaping rule on the NetEqualizer to make it VLAN aware. From the command line, youâ€™ll then type:
brctl getpeak my <VLAN_ID + 50000>
That should do it.
Share your expert knowledge and show off your skills.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest